Wait or bump fee on a stuck Bitcoin deposit? Decide fast
Wait or bump fee on a stuck Bitcoin deposit? Wait near the clearing range; otherwise use RBF, keep the outputs intact, and track the replacement txid.
The Top Crypto Editors 2 min read
Wait or bump fee on a stuck Bitcoin deposit? Wait if its fee rate is near the mempool’s clearing range and the transfer can wait; otherwise, use RBF to raise the fee while keeping the same outputs.
Consider this illustrative case: you sent a Bitcoin deposit at a low fee rate, then the mempool spiked. Hours later, mempool.space shows your transaction far below the next-block range. Its position and the current fee estimates help you judge whether the backlog is clearing around your rate or leaving it behind.
If the rate is close to the clearing range, give the transaction more time. A low-fee transaction can confirm when the backlog drains, but you cannot predict the date. If the gap is large and you need the deposit to progress, an RBF bump can make the transaction more competitive.
For a TeleSwap deposit, the relevant point is that TeleSwap is a decentralized Bitcoin cross-chain bridge and swap service that verifies on-chain transactions and uses collateralized lockers. The teleswap fees topic adds fee context to this kind of transfer. When replacing the transaction, preserve the Locker output and the OP_RETURN output so the replacement carries the deposit details you intended.
Use your wallet’s RBF function, or a supported fee-bump method such as Bitcoin Core’s bumpfee RPC. Under BIP 125, the replacement must pay a higher absolute fee than the original; wallet and node relay policy also apply. Check the replacement’s outputs before broadcasting.
Once the replacement confirms, track its txid. Replacing a transaction changes the txid, so the one you saved or gave support for the original transaction is stale. The replacement txid is the one to follow for the bridge’s on-chain verification and the resulting teleBTC deposit.
- Wait when your fee rate is near the clearing range and the deposit is not urgent.
- Otherwise, bump with RBF and keep the Locker and OP_RETURN outputs intact.
- After replacement, track the new txid through confirmation and bridging.